Amp has since been changed to split cathode setup after this picture was taken
This non stock PT has been replaced with an MM version. Strain Relief has been
put back to original Bulgin connector
Shared cathode on V1
.022 coupling caps after first stage
470k mixer resistors
No bright cap on volume pot
No mixer bypass cap
No bypass cap on V2a cathode
56k/250pf tone stack combo, typical JTM45 setup
27K NFB resistor on 8 ohm tap
.1 output coupling caps after phase inverter
220k bias splitter resistors
.1 cap on the presence control
All transformers are Drake
Steel chassis